DIY Home Decor: Make A Custom Decoupage Switch-Plate Cover
The craft of decoupage has been around for years. If you want to make a decorated switch plate cover you can purchase decoupage paper in just about any craft store, but why stop there? Why not make your own custom paper to match your decor?
You can use photos of curtains and comforter to create one of a kind switch-plate covers. You can create these covers on new switch-plates or just recycle your old ones for a unique room face-lift.
- Computer and printer
- Standard computer paper
- Gloss decoupage glue and finish (Modpodge is a good one)
- Small paintbrush
- X-acto or craft knife
- Scissors, ruler, pencil
- Piece of corrugated cardboard (scrap from a box) covered with waxed paper
- Switch-plate cover
Take a photo of any color, fabric, or textural surface that matches your room.
Load the photo of your choice on your computer and print the design full size on a sheet of standard all-purpose computer paper.
- Working on the wax paper covered cardboard place your design unprinted side up and lay your switch plate on top.
- Trace around the switch plate. Mark a ½” extra around entire traced piece.
- Trace the center opening as well and mark an X in the center.
- Cut out the traced piece and use the ruler to cut each corner at an angle.
- Using the X-acto or craft knife to cut the X in the switch opening.
With a small paintbrush spread a thick layer of decoupage glue on front of switch plate. Place the paper design on top of the switch plate centering so that the ½ inch edges overlap evenly and the X opening is in the proper place.
Smooth down with your fingers. (Mod Podge washes away easily with water) Turn over and working on one side at a time, spread some of the decoupage glue on each back edge and fold to the back. Smooth down the corners with your fingers.
Continue until all the edges are glued down. Do the same thing with the center opening folding down each triangle of the X inward and down.
Turn to the right side and apply a thick layer of decoupage glue to finish. Make sure you smooth out any bubbles with your fingers. Let dry. If you would like your switch plate to be extra shiny add another coat of decoupage glue and let dry.
When the switch plate is dry and you are ready to screw it back on the wall turn to the back side and make a tiny hole with a pen point so you can see where to put the screws.
This tutorial is brought to you by an artist and craft designer, Crystal Donnelly, who began writing in 1992. She has had her designs featured in national Craft publications such as “Crafts n Things,” “Pack O Fun”, and in the books, “Quick & Easy Christmas Crafts”, and “201 Bazaar Bestsellers.”
Her work has appeared on the television show, “Aleene’s Creative Living.” Donnelly studied liberal arts in the Virginia Community College System and Virginia Commonwealth University. Crystal is co-owner of a Saddlery store and is currently working on a leaflet detailing the dos and don’ts of equestrian wear.
Visit Crytal’s blog to see more of her awesome DIY tutorials!